Some Assembly required: Usually takes about 1 to 2 hours. The ATV is completely assembled in the factory and fully tested. Tires, battery, front bumper, and the handlebar are removed after testing. Item will be shipped in a crate, to assemble, put the above items back on. The handle bar assembly goes back on with just a bracket and four bolts. For safety precautions, be sure to check and tighten all nuts and bolts prior to use. Be sure to check for appropriate engine fluid levels to ensure your vehicle is operating under the recommended conditions prior to use.

Remember! You are responsible for performing the setup that a dealer would normally perform - such as putting on tires, hooking up the battery, checking tightness of all nuts and bolts, changing oil, etc. Occasionally some units may need other routine items checked/adjusted such as adjusting the carburetor idle and mixture screws, checking to ensure wires are well connected, adjusting chain slack and alignment, if needed. We will gladly assist you with any technical questions.

BE A RESPONSIBLE RIDER! FOR SAFETY, READ YOUR OWNER'S MANUAL. ALWAYS WEAR A HELMET, EYE PROTECTION, AND PROTECTIVE CLOTHING! NEVER RIDE UNDER THE INFLUENCE OF DRUGS OR ALCOHOL! Parents consider your youngster’s age, size, ability, and maturity before allowing them to ride. Never ride on paved streets or public roads, and never carry passengers on your ATV. Never engage in stunt driving or ride at excessive speeds. Be careful on difficult terrain. An adult must supervise riders under 16 years of age